Getting ready to get our warm sun back from those of you in the Southern hemisphere....
After flying my first AXN a bunch, I am feeling the need for even more speed. For my second AXN build, I am thinking about the following AXN build -- any suggestions or comments?
motor:
Dr Mad Thrust 3300kv 1100w 64mm EDF Inrunner Motor 4s version (29mm)
http://www.hobbyking.com/hobbyking/stor ... duct=29358
ESC:
Hobby King 90A ESC 4A UBEC
http://www.hobbyking.com/hobbyking/stor ... duct=17531
Toss in a 4S 1800mah or so. Maybe a bit less for weight issues.
Cut off the wingtips and place carbon rods in them so they can be removable.
I plan on reinforcing the carbon wing bar by glueing in smaller caliber hollow carbon tubes -- i.e. 5mm in the outer 6mm and possibly a 4mm in the 5mm.
the rest of the build is more or less standard from Bruce's online axn vids.
Propeller? No clue here really. I was thinking I would try a 6.5 and possibly a 7" if I can get clearance from the airframe.
I was going to perform a little surgery on the belly of the craft and cut out a rectangular piece for access to install the esc further back for balancing the CG-- or I might leave the esc in the open air on the side of the plane if heat is an issue.