Turnigy 9x v2

[aussiepaul]

Hi guys just wanted to start a new topic, i have the 9x vers 2 and need to find out how to setup flaps using the 3 position switch on a Multiplex funcub, have searched you tube but cant find one that is specific to just setting up flaps using the 3 position switch, if any has instructions on how to do this would be much appreciated.

[cynr100]

Hi Aussiepaul,

This may be of assistance, if you are using the stock 9x firmware.
http://9xforums.com/forum/viewtopic.php?f=37&t=1004
First, you must have one servo for each aileron and one channel for each servo, a 4ch Rx is not enough. I have not use the stock firmware for this, the er9x is much easier, how ever these condistions would still apply.

[Chris916]

Not quite sure how to use this form yet but I have a turnigy 9X put a life battery in it 9.9 V 1800 wondering at what voltage should I recharge it and does this radio have a low-voltage alarm that will go off when it's too low so I don't crash my planes does anybody know anything about these radios

[BillGriffiths100]

The low voltage alarm goes off at 9 volts on the standard software.

Lithium iron phosphate (LiFePO4) battery:
Min. discharge voltage = 2.8 V
Working voltage = 3.0 ~ 3.3 V
Max. charge voltage = 3.6 V
So charge at 9 volts or thereabouts

[Chris916]

Thanks for answering the last post you wouldn't happen to know what I charge 9.9 volt 1800 life battery at is it just like a Lipo 1.8?

[BillGriffiths100]

No it requires a lower cut off voltage see Bruces video about the turnigy charger he explains all:
see his video channels
http://www.youtube.com/watch?v=eX_Tuv6WOf8