Hi
I was flying my pitts biplane using my turnigy 9x/ frsky JR one way module radio when I lost the link to the model which went into failsafe and subsequently crashed.
While this was happening I looked at the screen and it had gone blank but the backlight was still working.
Immediately prior to the loss of signal I had tried to use the rudder trim. The radio made a series of rapid beeps as if the trim button was working , screen went blank and the beeps continued until I turned off the radio after the crash.
After the crash I turned off and re-started the radio which now seems to be fine. I have not managed to get the radio to fault again on the ground so am hoping for suggestions as to what may have been the cause.
The second thing is the pins on my radio seem to be a bit short and sometimes the module wont transmit unless I push it really hard into the radio. Is there anything I can do about this?
Please note. I feel the 2 problems are unrelated as when the module loses contact the screen is still ok.
Would much appreciate some suggestions as I prefer this radio to my futaba 6xas and don't wanna go back.
Cheers
Geoff