Binding bugs with Turnigy 9v2 & hk tr6a

[ivorn]

Hi to all my first post.
Have real problems binding my Turnigy 9 with HK tr6a. Going throught the proceedure and still no steady red light.
Most people seem to have no problem, but not working with me.
Does anyone have any answers?

Steps:
Bind plug into batt.
Esc into channel 3
Power up.
Transmitter off.
Hold down bind button.
Turn on transmitter... Nuthin!

[chrisjunkie]

Are you sure that the red light is supposed to go solid? I don't remember mine doing that?

[FlyingTiger]

Hold down the bind button and turn on the transmitter first. Then, with the bind plug already in the receiver and with your third hand, plug in the battery to the ESC to power up the receiver. You should now get a solid red light. Now release the bind button and turn off the transmitter. Unplug the battery from the ESC. Remove the bind plug from the receiver. To check, turn on the transmitter and then plug in the receiver. The red light should stay solid.

[ivorn]

Hi FT, tried that but no luck. Tried esc plugged into 3 socket and next to batt. Errrrrr
Think I'm running out of options...

[FlyingTiger]

Watch this video:

http://www.youtube.com/watch?v=zAemTY_w ... _embedded#!

I had it wrong. Turn on the Rx then hold the bind button while turning on the Tx. Release the bind button only after the red light goes solid.

[ivorn]

Tried that also, no go.Think I've tried every possible combo. Might try on a friends Turnigy. Can't think of what elso to try. Thanks for your help.

[RCModelReviews]

Make sure the model memory you're using is in PPM mode not PCM.

[ivorn]

Yes it is PPM.